BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ Manual transmission and transmission a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   The general information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a forward bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a back bumper
      Removal and installation of the back shock-absorber
      Removal and cover installation обтекателя
      Removal and installation of a forward wing
      Removal and cowl installation
      Cowl adjustment
      Removal and installation of a cover of a luggage carrier
      Adjustment of a cover of a luggage carrier
      Removal and installation of the lock/cylinder of the lock of a cover of a luggage carrier
      Removal and installation газонаполненного an emphasis of a cowl/cover of a luggage carrier
      Replacement молдингов and model emblems
      Removal, installation and door adjustment
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and window adjustment
      Removal and installation electric window lifterа
      Removal and electric motor installation window lifterа
      Removal and installation of a mirror of an external kind / a sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ Electric equipment schemes



Removal and installation/check of shock-absorbers of a bumper

 REMOVAL

1 Remove the forward shock-absorber.

2 Disconnect the shock-absorber-1. For this purpose turn away a nut-3.

On a place of nuts-3 there can be rivets. In this case them it is necessary засверлить. Turn away a nut-2 and take out the shock-absorber. If there is a connector of a cable-4, preliminary open it and turn on.


 CHECK

3 Measure length of the shock-absorber from the centre of a plastic insert to a basic surface. If the received value less than 127.5 1 mm, replace the shock-absorber.


 INSTALLATION

4 Insert into place the shock-absorber and fix its moment 50 Н•м (a key on 13 mm) or 10 НЧм (a key on 8 mm) or приклепайте usual explosive rivets.
5 Fix a cable connector if he acted in film and fix a cable.
6 Establish a forward bumper.