BMW 3 series E46

1 Mark a paint position of a forward wheel concerning a nave. It will allow to establish отбалансированное a wheel in the former position. Loosen the bolts of fastening of a wheel at the car standing on the earth. Lift a forward part of the car and remove a wheel
2 Remove the bottom cover of an impellent compartment, address to Section Removal and installation of the bottom cover of an impellent compartment.
3 Remove by means of a stripper the hinge of steering draught from a rotary fist, address to Section Removal and installation of a tip of steering draught.

4 Oslabte fastening of a collar also shift back a cover.

5 Move gear рейку as it is possible more deeply to exclude possible damage рейки and its support.

6 Turn away steering draught from gear рейки (an arrow on an illustration).

7 Measure gear рейку. If new steering draught is established, screw it so that to provide the size which has been removed at measurement of old draught.
8 Tighten a tightening nut of a tip of steering draught the moment 80 Н•м.
9 If it is necessary, clear of greasing a pin of the hinge of steering draught, and also a seat in a rotary fist.
10 Check up a cover and if necessary replace it.
11 Fix steering draught not gear рейке the moment 100 Н•м.
12 Put on a cover and fix its collar. Watch that the cover has not been braided.
13 Insert a tip into a rotary fist. Screw a new self-stopped nut on a pin of the hinge of steering draught and tighten the moment 65 Н•м.
14 Establish into place a wheel so that the marks put at removal, have coincided. Preliminary grease with a thin layer подшипниковой greasings a seat of a disk of a wheel on a nave. Bolts of fastening of a wheel do not grease. Rusty bolts replace with the new. Fix a wheel bolts. Lower the car on wheels and tighten bolts cross-wise the moment 100 Н•м.
15 Establish the bottom cover of an impellent compartment, address to Section Removal and installation of the bottom cover of an impellent compartment.
16 Check up a track on HUNDRED, if necessary adjust.