|
|
BMW 3 series E46Since 1998 of releaseRepair and car operation |
|
|
The BMW of 3 series Е46 + Cars BMW 3 (Е46) - Current leaving and service Introduction Current leaving The general information on adjustment Check of levels of liquids Check of a condition of tyres and pressure in them. A designation of tyres and disks of wheels Replacement of impellent oil and the oil filter Replacement of a filtering element of the air filter Checks of brake system Replacement of an element of the filter of air of salon Condition check drivers ridge belts Check of a condition and replacement of hoses of an impellent compartment Check of functioning of system of cooling and frost resistance of a cooling liquid Check of a condition of system of release of the fulfilled gases Check of level of oil in a manual box of a gear change Check of a condition of components of a suspension bracket and steering Check of a condition of protective covers of power shafts Check of level of a liquid of system of hydrostrengthening of a wheel Visual check of a body and its bottom Check of seat belts Rotation and replacement of wheels Condition check, replacement of brushes and adjustment of a corner of screen wipers Check of a condition of the battery, care it and gymnastics Replacement of a brake liquid Check and replacement of spark plugs Check of fuel system, replacement of the fuel filter. Operation of diesel model in the conditions of winter Greasing of loops and locks of doors Replacement of a battery of a key of remote control + The engine + Systems of cooling, heating + Power supply systems, injection and release + Engine electric equipment + Manual transmission and transmission a line + Automatic transmission + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment + Electric equipment schemes |
Rotation and replacement of wheels
2 At faster deterioration of forward tyres it is recommended to interchange the position of forward and back tyres. Thus, service life of all four tyres is equalised. 3 Address to the information in Razdele Poddomkrachivanie and towage for a correct raising of the car at wheel replacement. 4 Car should be lifted on the lift or to establish it on support that all four wheels have been lifted over the earth. Make sure that the car is reliably fixed!
Spare wheel 6 Spare wheel can be established both on a lobby, and on a back axis. 7 Spare wheel is intended only for short-term use and it is necessary to replace it with the usual as soon as possible. 8 After installation of a spare wheel pressure in its tyre should make 4.2 bar. 9 With the established spare wheel it is impossible to exceed speed of 80 km/hour. It is necessary to avoid the maximum acceleration of the car, intensive braking and sharp turns. 10 At installation of a spare wheel the road gleam under a corresponding axis decreases approximately for 30 mm. It is not necessary to apply spare wheels from cars of other types. It is not supposed to establish two or more spare wheels. Replacement of wheels 11 Remove a decorative cap of a wheel. 12 On the car standing on the earth, tighten a manual brake and ослабьте bolts of fastening of a wheel. 13 Lift the corresponding party of the car and fix on supports.
15 For an exception “прикипания” disks of wheels to a nave, before wheel installation, apply a thin film greasings on the fillet of a nave aligning a disk of a wheel. 16 Zinced wheel bolts can be applied only on capital stamped disks. 17 Disks from easy alloys fasten only the chromeplated wheel bolts on which there is a conic rotating washer. This washer established under a head of a bolt, protects a disk surface at a tightening of bolts. 18 Before ввинчиванием do not grease a carving of bolts of fastening of a wheel. Chains противоскольжения 20 Chains should be established only on forward wheels, as well all-wheel drive car. 21 Chains противоскольжения can be established only on tyres dimension 195/65 R 15. Installation of chains противоскольжения on an emergency wheel for technical reasons is not supposed. 22 it is necessary to use only мелкоячеистые the chains acting no more than on 15 mm (including замковые links). 23 At installation of chains противоскольжения it is necessary to remove full-size caps of wheels and decorative rings of disks. For safety reasons wheel bolts should be protected special caps. 24 Before movement on free from snow it is necessary for way site to remove chains противоскольжения. They worsen road performance of the car, raise deterioration of tyres and quickly collapse. |
|