BMW 3 series E46

320i

2 Remove soaking up pipeline at valve AGR (system recycling the fulfilled gases) for what open a collar, address to Section Removal and installation of the inlet pipeline.

3 Diesel engine has jalousie of a radiator with a pneumodrive, located behind the fan. Disconnect a vacuum hose-1 from a vacuum box. Remove draught of a drive from jalousie for what remove sideways a clamp-2.

4 Take out a small screw-driver a rivet-3.
5 Models 320i, 323i, 328i with the conditioner: Remove the fan with вязкостной муфтой, address to Section Removal and installation of the fan with вязкостной муфтой.

6 Rasstykujte to the right of a radiator a socket-1 electrofans.

7 Turn out the screw-2.

8 Take out a rivet in a point-1 at the left. The rivet on an illustration is not shown.

9 Slightly press back on a fan casing in the centre from above and disconnect directing lath. Take out together a casing of the fan and крыльчатку upwards.

10 Models 320d: Turn away the screw of fastening-1 and four others of the screw of fastening of jalousie of the fan and remove it from a fan casing.

11 If necessary turn away three screws of fastening of a casing of the fan and remove the electric motor.

12 Fix the fan electric motor on a casing three screws.
13 Models 320d: Fix screws of jalousie of the fan on a casing.
14 Insert a fan casing from above so that both bottom laths of fastening have entered into eyes on the fan.

15 Fix a casing of the fan a rivet at the left on a radiator. The damaged clips replace.

16 Screw the screw-2 on the right at a radiator.

17 Join a socket of the electrofan and fix it.

18 Models 320d: Connect a vacuum hose-1 to a vacuum box. Connect draught of a drive to the lever of jalousie of a radiator and fix a clamp-2. Insert a rivet-3.

19 Models 320d: Connect soaking up hose to valve AGR and fix a collar.
20 Insert directing soaked up air, insert a rivet and fix pins.