BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ РКПП and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   The general information and security measures
   + Leaving and repair of damages of a body
   + External elements of a body
   - Internal elements of a body
      Removal and installation of forward peaks of the panel of devices
      Removal and facing installation forward parts of area of feet
      Removal and installation of the left ware box
      Removal and installation of the right ware box
      Removal and installation of the central console
      Removal and installation of the central armrest
      Removal and installation of a pocket of the console of switches
      Removal and installation of the console of switches
      Removal and installation of the electric motor of a drive сдвижной roof panels
      Removal and installation of a mirror of an interior
      Mirror of an interior with automatic blackout
      Removal and installation of lateral facing of a luggage carrier
      Removal and installation of facing of the back panel
      Removal and installation of facing of a cover of a luggage carrier
      Removal and installation of a headrest of a forward seat
      Натяжитель a seat belt. The basic data and security measures
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of atomizers стеклоомывателя
      Adjustment of atomizers стеклоомывателя
      Removal, installation and check of atomizers фароомывателя
      Removal and installation of levers of a screen wiper
      Removal and installation of the tank/pump of a washer
+ Onboard electric equipment
+ Electric equipment schemes
актерм, go.



Removal, installation and check of atomizers фароомывателя

 REMOVAL

1 Take out an atomizer-1 by means of a plastic wedge-2 of обтюратора headlights and extend it against the stop.

At atomizer removal water follows, therefore cover an atomizer with a rag and substitute the corresponding capacity. If necessary insert into a tube a corresponding stopper.

2 Remove jerky an atomizer from a tube. The tube after that itself departs back.


 INSTALLATION

The left and right atomizers differ from each other. Not to mix them, they have on the bottom part marks “R” and “L”. If the atomizer is replaced, disconnect обтюратор and rearrange it on a new atomizer.

3 Insert an atomizer into an aperture in обтюраторе headlights and enter into a tube.
4 Take out an atomizer check up, whether the tube on joining is fixed. If necessary put on it and fix.
5 Insert an atomizer in обтюратор headlights.


 CHECK

6 Include ignition, include light and ask the assistant to include the switch стеклоомывателя.
7 Stream of water should get to the centre of a headlight of near and far light.

If фароомыватель should join again, it is preliminary necessary to switch on and off ignition as differently the washer is blocked on 3 mines

8 If necessary adjust atomizers.