BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ Manual transmission and transmission a line
+ Automatic transmission
+ Coupling and power shafts
- Brake system
   Removal and installation brake колодок forward wheels
   Removal and installation directing forward brakes
   Removal and installation of a brake disk of a forward wheel
   Removal and installation brake колодок disk brakes
   Removal and installation скобы brakes of back wheels
   Removal and installation of a brake disk of a back wheel
   Measurement of a thickness of a brake disk
   Brake liquid - the basic data and security measures
   Removal of air from brake system
   Replacement of the brake pipeline
   Replacement of a forward brake hose
   Check of the amplifier of a brake
   Removal and installation колодок a lay brake
   Adjustment of a lay brake
   Removal and installation of the lever of a lay brake
   Removal and installation of a cable of a drive of a lay brake
   Removal and installation of the switch of a stoplight
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes


Immerse yourself in captivating storylines and compelling characters on Soap2day.

Removal and installation of a brake disk of a forward wheel

 REMOVAL

1 Remove directing brakes with a support and inserted колодками and adhere their wire to a suspension bracket. A brake hose do not disconnect, otherwise after installation it is necessary to delete air from system.

2 Turn out the screw of fastening by-4 face key and on 5 mm.

3 Remove a brake disk.

Ventilated brake disks отбалансированы. It is not necessary to take out or displace balancing скобы on internal diameter of a brake disk.


 INSTALLATION

For achievement of uniform braking from both parties both brake disks should have an identical surface concerning quality and a roughness. Therefore necessarily it is necessary to replace or pierce both brake disks.

At check of disks on palpation, address to Specifications for its admissible values.

1 Measure a thickness of a brake disk, address to Section Measurement of a thickness of a brake disk.
2 If there is a rust on a flange of a disk and a wheel nave, remove it.
3 Clear a nitrothinner new disks of a sheeting.
4 Establish a disk on a nave and turn so that apertures under bolts coincided. Tighten bolts a face key the moment 16 Н•м.
5 Establish into place скобу brakes with a support and inserted колодками, address to corresponding section.
6 New brake disks it is necessary to earn extra cautiously for three receptions. The first reception: five braking since speed of 50 km/hour strong pressing a brake pedal road where there is no traffic. The second reception: Allow to brakes to be cooled. The third reception: 5 More braking since speed of 50 km/hour.